Part Number Hot Search : 
LT161 S2136 45G20B1 LC1126 OK53025 SFBFT53 EER90 CDT3332
Product Description
Full Text Search
 

To Download BP5034A5 Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 Regulator ICs
AC / DC converter unit
BP5034A5
The BP5034A5 is an AC / DC converter that provides a direct current (5V) from commercial power supply (100V, AC), with a small number of external components required. Using this IC, a compact microcontroller-based device can be configured without a transformer. FApplications Power supplies for vacuum cleaners, rice cookers, electric pots, steam irons, telephones, electric heaters, lighting equipment, gas leakage alarms, and sensors FFeatures 1) Smaller and lighter than transformers. 2) Wide range of input voltage (80 X 120V, AC). 3) Few external components required. 4) Power supply board is resistant to impacts because a transformer is not used. FAbsolute maximum ratings (Ta = 25_C)
5) The hybrid IC allows easy assemblage of components.
FElectrical characteristics (unless otherwise noted, Ta = 25_C)
1
Regulator ICs
FMeasurement circuit
BP5034A5
1 Pin 6 is the COMMON pin and is connected internally to pin 5. Use eitcher both, or one or the other, as the COMON pin. Keep open the other pins that are not used.
FBasic circuits
2
Regulator ICs
FApplication example Example of a vacuum cleaner application The diode bridge, which draws out a zero-cross signal,
BP5034A5
is not required if a zero-cross signal is not used.
Example of a rice cooker application
3
Regulator ICs
FSelecting attached components (1) Diodes Use rectifier diodes with the following absolute maximum ratings: minimum peak reverse voltage is 400V, the mean rectifying current is more than 0.5V, and minimum peak forward surge current is 20A. For example, 1SR35-400A is recommended. (2) Input voltage smoothing capacitor When the capacitance of this capacitor is increased, the output voltage is stabilized but the start-up rush current is increased. The waveforms of rush currents for capacitance values of 3.3F (Fig. 5) and 10F (Fig. 7) are shown in Figs. 6 and 8, respectively. The recommended capacitance is plotted against the output current in Fig. 9. The capacitor must have a withstand voltage of at least 200V. Application circuit 1 (CIN = 3.3F)
BP5034A5
(3) Output voltage smoothing capacitor Use a capacitor with a small ESR. Specifically, a low-impedance capacitor for power supply switching is recommended. The capacitor's ESR affects the output ripple voltage. Capacitor products are listed below for reference.
Rush current waveform
4
Regulator ICs
Application circuit 2 (CIN = 10F)
BP5034A5
Rush current waveform
5
Regulator ICs
FOperation notes (1) Output current should be reduced with increasing ambient temperature. (2) Pins 3 and 7 are internally connected. Use the IC with these pins OPEN. (3) Overcurrent and short-circuit load The overcurrent protection circuit limits the current to about 160mA with a curve shape of "inverted -L" in the voltage-current graph. The IC may be damaged if the duration of intermittent overcurrent flows of more than 100mA exceeds 1 minute in total at 25_C. Be sure to take safety measures such as fusing if short-circuit loads or Conditons A R2 = 0 (), C = 200pF
BP5034A5
overcurrent is probable. Though a 0.5A continuous break fuse is recommended, careful selection should be made according to the loading condition. (4) Regulations governing electrical products A single IC (BP5034A5) unit is not subject to the Regulations on Electrical Appliances. An application for approval should be based on an assembled unit. (5) Surge tolerance Results of electrostatic breakdown tests are shown in Fig. 11. The test methods are based on EIAJ ED-4071 and C-111.
Conditions B R2 = 1.5 (k), C = 100pF
Measurement circuit
6
Regulator ICs
(6) Pin noise voltage Results obtained by using the Measurement circuit of Fig. 13 are shown in Fig. 12.
BP5034A5
7
Regulator ICs
FElectrical characteristic curves (Measurement circuit is Fig. 8)
BP5034A5
FExternal dimensions (Units: mm)
8


▲Up To Search▲   

 
Price & Availability of BP5034A5

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X